BMW F11 2014 how to read DDE 520D N47T - Printable Version +- CarTechnoloGY (https://cartechnology.co.uk) +-- Forum: All About IMMO/ECU , ChiPTuninG , Dashboard , Locksmith , AirbaG , Carradio (https://cartechnology.co.uk/forumdisplay.php?fid=3) +--- Forum: CHIPTUNING (https://cartechnology.co.uk/forumdisplay.php?fid=12) +--- Thread: BMW F11 2014 how to read DDE 520D N47T (/showthread.php?tid=45701) |
BMW F11 2014 how to read DDE 520D N47T - Fx82 - 28-01-2019 For a BMW F11 2014 520D with engine code N47T p/n 8577764 I would like to remove egr. I have KessV2 K-tech clone. What possibilities do I have to read out the ecu? Do I need to open the cover? The ecu has already be chipped by a tuner. Bosch 0 281 030 759 RE: BMW F11 2014 how to read DDE 520D N47T - ltujustas - 28-01-2019 Read/write with opening ecu. I know that autotuner can read/write without taking out ecu but there is virtual read... Bdm read/write best solution for f-series ecu. RE: BMW F11 2014 how to read DDE 520D N47T - Enabled - 28-01-2019 That is EDC17C50 right? KTAG GPT boot mode works well, opening dde is not too bad. I have done a lot on personal car with this dde. RE: BMW F11 2014 how to read DDE 520D N47T - Fx82 - 28-01-2019 How can I check if it is EDC17C50? What version of KTAG should be used? I'll post tomorrow a list what ecu's are supported of the KTAG version I'm using. RE: BMW F11 2014 how to read DDE 520D N47T - Enabled - 29-01-2019 RealOEM says it is DDE7.01, so that should be EDC17C50. Easy. I use KTAG 7.020, with K-Suite 2.23. (If by any chance it is DDE7.31, then that is a very difficult to open EDC17CP45.) RE: BMW F11 2014 how to read DDE 520D N47T - pepi - 29-01-2019 (28-01-2019, 23:02 PM)Fx82 Wrote: How can I check if it is EDC17C50? Post label attached on ECU. RE: BMW F11 2014 how to read DDE 520D N47T - Fx82 - 01-02-2019 Let me get a picture of it. RE: BMW F11 2014 how to read DDE 520D N47T - Enabled - 01-02-2019 Your part number from above, Googled, shows it as the 2 connector (1 large, 1 small) EDC17C50. RE: BMW F11 2014 how to read DDE 520D N47T - Fx82 - 03-02-2019 (01-02-2019, 01:21 AM)Enabled Wrote: Your part number from above, Googled, shows it as the 2 connector (1 large, 1 small) EDC17C50. Here is a picture of the numbers from the ecu. RE: BMW F11 2014 how to read DDE 520D N47T - Fx82 - 04-02-2019 I've succeeded in reading the EDC17C50 ecu Thanks all for the help |