Megane 3 column lock fault - Printable Version +- CarTechnoloGY (https://cartechnology.co.uk) +-- Forum: All About IMMO/ECU , ChiPTuninG , Dashboard , Locksmith , AirbaG , Carradio (https://cartechnology.co.uk/forumdisplay.php?fid=3) +--- Forum: IMMO & LOCKSMITH (https://cartechnology.co.uk/forumdisplay.php?fid=9) +--- Thread: Megane 3 column lock fault (/showthread.php?tid=47998) |
Megane 3 column lock fault - Stevo - 14-03-2019 Hi all. 62 plate megane 3 with a fault relating to column lock. Clip states after ign feed missing. The feed (yellow wire) according to wiring diagram comes from UPC via a 10 amp fuse - yet its not at the lock. However by adding my own 12v to the lock still has a problem. I have bypassed the lock with a emulator just to rule out the lock. Apart from an earth to the lock all other wires including multiplex goes to the UCH. Anybody had anything similar ? Thanks steve RE: Megane 3 column lock fault - rightpcb - 14-03-2019 What fault codes you have ? RE: Megane 3 column lock fault - Stevo - 16-03-2019 (14-03-2019, 20:06 PM)rightpcb Wrote: What fault codes you have ? Fault code dtc 95531c which relates to column lock supply- fault finding suggest apc relay but not shown on the wiring diagram unless built in the UPC ? RE: Megane 3 column lock fault - Sergiochaparro - 01-05-2019 if you made sure that the feeds are correct, remove the module, uncover, (replace) or perform maintenance. the screws are in reverse. |