Column lock Chrysler C300 Skreem Wcm - Printable Version +- CarTechnoloGY (https://cartechnology.co.uk) +-- Forum: All About IMMO/ECU , ChiPTuninG , Dashboard , Locksmith , AirbaG , Carradio (https://cartechnology.co.uk/forumdisplay.php?fid=3) +--- Forum: IMMO & LOCKSMITH (https://cartechnology.co.uk/forumdisplay.php?fid=9) +--- Thread: Column lock Chrysler C300 Skreem Wcm (/showthread.php?tid=48150) |
Column lock Chrysler C300 Skreem Wcm - yomgui - 17-03-2019 Hi friends. I have a start up concern about a 2009 Chrysler 300C 3.0 CRDI. I changed the glow box module because it came out as a fault code. Then it started 2 minutes then cut off and since impossible to restart. The fault code now is B2224 Vehicle Security Control Module (Skreem / Wcm) and the steering column does not lock. A solution friends? I am equipped with a programmer so if it is necessary to correct the electronics by reinjecting a file must tell me. thanks in advance RE: Column lock Chrysler C300 Skreem Wcm - AROUNDLOCKS - 17-03-2019 hi ive had a quick look at your fault its saying wcm internal faultĀ did you disconnect battery from car when changing glow plug module is immobilizer light staying onĀ permanent if you have a spare key try it to rule out a key fault also there are 3 fuses to the immobilizer system on this car /please check all fuses are all ok in your fuse board in the boot of your car. check all above and reply back here regards aroundlocks RE: Column lock Chrysler C300 Skreem Wcm - yomgui - 17-03-2019 Hi, no I did not disconnect the battery when replacing the preheating module. I only cleared the fault codes with the pc. I will try to unplug the battery for 10 minutes to be sure of everything. in any case the fuses in the trunk and in the engine are ok |