Peugeot 2008 2017 odometer correction by OBD? - Printable Version +- CarTechnoloGY (https://cartechnology.co.uk) +-- Forum: All About IMMO/ECU , ChiPTuninG , Dashboard , Locksmith , AirbaG , Carradio (https://cartechnology.co.uk/forumdisplay.php?fid=3) +--- Forum: DASHBOARD (https://cartechnology.co.uk/forumdisplay.php?fid=10) +--- Thread: Peugeot 2008 2017 odometer correction by OBD? (/showthread.php?tid=51740) |
Peugeot 2008 2017 odometer correction by OBD? - andi1571 - 02-06-2019 Next week i have a car coming in 2017 Peugeot 2008 for odometer correction id like to try to do this obd as its a mobile job at customer house not in workshop Has anyone done these before and which tools did you use? i think it has the valeo no 3 bsi Tools i have are:- fvdi 2018 Blue digi prog 3 clone Green obd star h108 psa obd prog mt401 thanks in advance RE: Peugeot 2008 2017 odometer correction by OBD? - David89 - 02-06-2019 Hello, I do not know exactly, but I suppose that SMOK UHDS with the PSA Module will do it. RE: Peugeot 2008 2017 odometer correction by OBD? - andi1571 - 02-06-2019 thanks but i dont have smok im afraid RE: Peugeot 2008 2017 odometer correction by OBD? - giiintas - 02-06-2019 hi x tool bsi obd and clocks by epprom adapter only tested RE: Peugeot 2008 2017 odometer correction by OBD? - andi1571 - 02-06-2019 Thanks so on this model do you have to both the bsi and the clocks separately ? And in which order? RE: Peugeot 2008 2017 odometer correction by OBD? - jomberykaso - 03-06-2019 I do that model with upa programmer, in any order but when i conect modules back, I always connect bsi first and then dash. I dont trust in obd2 tools RE: Peugeot 2008 2017 odometer correction by OBD? - andi1571 - 04-06-2019 ok thanks ive found that the dash has a 95320 so does anyone know if digi prog 3 clone will read it ok if i de-solder the eprom? RE: Peugeot 2008 2017 odometer correction by OBD? - volavka - 04-06-2019 (04-06-2019, 02:56 AM)andi1571 Wrote: ok thanks ive found that the dash has a 95320 so does anyone know if digi prog 3 clone will read it ok if i de-solder the eprom? You can read eeprom by digiprog and export dump to PC if your tool ftdi based , Otherwise Post screenshot of area's 0x3a0 and 0x3b0 so we will provide you bytes where need to change Bsi should be corrected with same value as well , it should be Valeo Bsi with eeprom 95256 Good luck |