+- CarTechnoloGY (https://cartechnology.co.uk)
+-- Forum: Discussions All about Software and Hardware (https://cartechnology.co.uk/forumdisplay.php?fid=310)
+--- Forum: Automotive Help & Discussions / Software and Hardware (https://cartechnology.co.uk/forumdisplay.php?fid=40)
+---- Forum: BMW - Mini - Rolls Royce (https://cartechnology.co.uk/forumdisplay.php?fid=61)
+---- Thread: Connect icom with tool32 (/showthread.php?tid=55482)
Connect icom with tool32 - Bimmer540 - 24-08-2019
How to connect icom with tool32.
All other programs like inpa, dr. Gini works whitout
problems.
Ediabas.ini
Remote and ip from icom and reserve in itoolradar,
But tool32 will not connect?
RE: Connect icom with tool32 - hashtagmaster - 24-08-2019
use ediabas konfigurator 2.0 = REMOTE
RE: Connect icom with tool32 - Bimmer540 - 24-08-2019
(24-08-2019, 11:13 AM)hashtagmaster Wrote: use ediabas konfigurator 2.0 = REMOTE
I use REMOTE
RE: Connect icom with tool32 - Enabled - 24-08-2019
Instructions are easily found here on cartech..
Use itool radar, get IP.
Un easyconnect choose remote, type in IP address of ICOM, choose OBD_ab625
Lock (reserve) ICOM, click Check. Use INPA, NCS, WinKFP, tool32
RE: Connect icom with tool32 - Matthew53 - 24-08-2019
The easier way is to use dr.Gini.
Set your ICOM IP in Ediabas and then always when you want to connect with standard tools - just open dr.Gini > Interface > Allocate> Connect.
It will show KL15 and KL30 voltages when connection will be estabilished.
Close Dr.Gini and use whatever you want.
RE: Connect icom with tool32 - jararak - 25-08-2019
if inpa works, than tool32 have to also, maybe you have broken instalation