Using x-tool eu to change bmw 2010 e91 cas 3 / dash odometer - Printable Version +- CarTechnoloGY (https://cartechnology.co.uk) +-- Forum: All About IMMO/ECU , ChiPTuninG , Dashboard , Locksmith , AirbaG , Carradio (https://cartechnology.co.uk/forumdisplay.php?fid=3) +--- Forum: DASHBOARD (https://cartechnology.co.uk/forumdisplay.php?fid=10) +--- Thread: Using x-tool eu to change bmw 2010 e91 cas 3 / dash odometer (/showthread.php?tid=56191) |
Using x-tool eu to change bmw 2010 e91 cas 3 / dash odometer - andi1571 - 09-09-2019 Hi im using x-tool.eu to change bmw miles but dash board is gone to 0 zero miles i think i may have done something wromg? I read dash 35080 edit mileage by direct to chip using soic crocodile as instruction told me to set to to new 60123 miles then i leave dash out of car and set cas 3+ mileage to 0 miles as per instructions by obd - sucesss I put dash back in car but the miles is now 0? Does anyone know where i went wrong here it appears the dash is displaying the cas mileage and not taking the miles from the dash as we neeed it to? thanks RE: Using x-tool eu to change bmw 2010 e91 cas 3 / dash odometer - rs@chip - 09-09-2019 (09-09-2019, 13:20 PM)andi1571 Wrote: Hi im using x-tool.eu to change bmw miles but dash board is gone to 0 zero miles power up cluster only without cas conected and check mileage,if its on 0-zero than edit odo 35080 again.. RE: Using x-tool eu to change bmw 2010 e91 cas 3 / dash odometer - andi1571 - 09-09-2019 Ok im not sure how to power clocks out of car as i dont have test leads but ive just re-read the 35080 with x-tool and its confirmed the km to be 60123 miles / 97392 km so everything in clocks looks to be good. Do you think i should just sen cash miles to same km ? RE: Using x-tool eu to change bmw 2010 e91 cas 3 / dash odometer - atomantmk - 10-09-2019 Using crocodile clip on M35080 is a bad idea, desolder, read, change KM and write. I have X-Tool too and done more cars as is described in this tool. RE: Using x-tool eu to change bmw 2010 e91 cas 3 / dash odometer - YoungElectronic - 20-09-2019 35080 work only adapter for this EEP Use VVDiprog or R270 , work good and clear ODO area Clip is bad solutions. |