+- CarTechnoloGY (https://cartechnology.co.uk)
+-- Forum: Discussions All about Software and Hardware (https://cartechnology.co.uk/forumdisplay.php?fid=310)
+--- Forum: Automotive Help & Discussions / Software and Hardware (https://cartechnology.co.uk/forumdisplay.php?fid=40)
+---- Forum: Mercedes Benz - Smart (https://cartechnology.co.uk/forumdisplay.php?fid=63)
+---- Thread: Monaco / Vediamo Project files (/showthread.php?tid=58434)
Monaco / Vediamo Project files - BigPat - 24-10-2019
Greetings,
I hope someone can help with Monaco Project files for W203 and W904. I purchased the dev kit from MBstarTool and have got heaps of project files but none for w203 or w906.
Can any kind users here help me out?
Also Vediamo does not communicate with the vehicle gives TX send error, have tried all control units on Both communication channels but still cannot talk. Done allot of research cant find anything except I must be on the wrong control unit but as Isay tried all units on w203 none work. Is this problem with SD connect c4?
If anyone can help me please willing to pay if you have a solution.
Thanks, Pat
RE: Monaco / Vediamo Project files - gcs190 - 24-10-2019
If I'm not mistaken, with Vediamo 5 and C4 you will have problems in those older vehicles that work through K lines, such as the W203.
RE: Monaco / Vediamo Project files - BigPat - 24-10-2019
Sounds very plausible, some of the modules I am trying to connect to do not come up with the CAN selection when pressing ALT+J.
Does this mean I would be better to remove unit and program out of car? or is there a better way?
Please forgive my ignorance.
Thanks, Pat
RE: Monaco / Vediamo Project files - gcs190 - 24-10-2019
Install Vediamo V4, you should not have problems with lines K and C4.
RE: Monaco / Vediamo Project files - BigPat - 24-10-2019
Thanks, I have found and installed a vediamo V4 copy and did a complete clean install.
I still cannot talk to the W203. If I go open OBD2 in ECUNOTE the same error appears. What am I doing wrong? could it be a faulty C4? It works perfect with Xentry use it often.
Got it working I think.
For anyone else struggling with same issue I had to set my communication parameters in start centre to part W: SD connect after clicking update
Thanks gcs
RE: Monaco / Vediamo Project files - gcs190 - 25-10-2019
(24-10-2019, 23:09 PM)BigPat Wrote: Thanks gcs
He doesn't deserve them, I'm glad I helped you.