Audi a3 8p 2009 cluster dashboard failure 00003 - 014 defective - Printable Version +- CarTechnoloGY (https://cartechnology.co.uk) +-- Forum: All About IMMO/ECU , ChiPTuninG , Dashboard , Locksmith , AirbaG , Carradio (https://cartechnology.co.uk/forumdisplay.php?fid=3) +--- Forum: IMMO & LOCKSMITH (https://cartechnology.co.uk/forumdisplay.php?fid=9) +--- Thread: Audi a3 8p 2009 cluster dashboard failure 00003 - 014 defective (/showthread.php?tid=59058) |
Audi a3 8p 2009 cluster dashboard failure 00003 - 014 defective - century-voyager - 15-01-2022 Hi there, I changed the battery in my a3 8p. Before the exchange, the instrument cluster had no errors. After the swap, I ran an error scan with VCDS. Now the instrument cluster has the following error, which cannot be deleted. Failure 00003 Control Modul - 014 defective The instrument cluster works despite the error. I just disconnected the battery, nothing else. Can this error be repaired? regards RE: Audi a3 8p 2009 cluster dashboard failure 00003 - 014 defective - koyot - 15-01-2022 cannot be repaired sometimes error disappears by itself RE: Audi a3 8p 2009 cluster dashboard failure 00003 - 014 defective - century-voyager - 15-01-2022 What problem has the cluster ? Can I break down with the vehicle if the instrument cluster breaks completely? RE: Audi a3 8p 2009 cluster dashboard failure 00003 - 014 defective - century-voyager - 17-01-2022 Why it cannot be repaired ??? RE: Audi a3 8p 2009 cluster dashboard failure 00003 - 014 defective - al70 - 17-01-2022 you won't break down on the road if cluster fails have you any faults in other modules ? RE: Audi a3 8p 2009 cluster dashboard failure 00003 - 014 defective - evg_eni - 17-01-2022 it is not typical for this error to occur simply by disconnecting the battery. it is usually due to a correction with poor quality cable. It can only be repaired by completely rewriting the software. Are there any errors in 25 immobiliser? RE: Audi a3 8p 2009 cluster dashboard failure 00003 - 014 defective - century-voyager - 18-01-2022 No errors in 25. How to rewrite software ? I have x-prog here. I can make dump of micronas RE: Audi a3 8p 2009 cluster dashboard failure 00003 - 014 defective - evg_eni - 18-01-2022 Yes, xprog is right tool, findĀ good flash+eep transfer your immo and write RE: Audi a3 8p 2009 cluster dashboard failure 00003 - 014 defective - lupu_sandu - 18-01-2022 Error appear after mileage correction via obd because of patching of Micronas dump. Only tool that can make odo without patch is dashcoder, AFAIK. RE: Audi a3 8p 2009 cluster dashboard failure 00003 - 014 defective - century-voyager - 18-01-2022 i only disconnected battery, nothinmg more, i have not modified mileage or something written in odo... Before there were no errors in dashboard, i have read error code with vcds over obd... Has VCDS caused these error, reading the fault memory ???? |