CBS - brakes 255% E9x - Printable Version +- CarTechnoloGY (https://cartechnology.co.uk) +-- Forum: Discussions All about Software and Hardware (https://cartechnology.co.uk/forumdisplay.php?fid=310) +--- Forum: Automotive Help & Discussions / Software and Hardware (https://cartechnology.co.uk/forumdisplay.php?fid=40) +---- Forum: BMW - Mini - Rolls Royce (https://cartechnology.co.uk/forumdisplay.php?fid=61) +---- Thread: CBS - brakes 255% E9x (/showthread.php?tid=59535) |
CBS - brakes 255% E9x - Darmand - 22-01-2022 Hi all A strange problem. E92 M3 - 2012, looses power when reset of brake Pads by Kombi (new BMW wear indicators fitted, 2 in front & 1 in back) After that, reset can't be performed on brake Pads. When I check the car with ISTA, CBS says 255% for both front & rear brakes. I'm not able to reset them to 100% ? Front brake is OK with 40.000 KM for example - but still at 255%. When reading from Tool32 - DSC_87.prg - mileage is -32768 KM for both. 2 errors is in DSC module with the overdue Brakepad mileage. 5DE0 5DE1 I've thied this: Open up Tool32.exe (in the C:\EDIABAS\BIN folder). Open File (or just press F3) 'DSC_87.PRG' (in the ECU folder). In the left Column, under Jobs, choose CBS_RESET. To reset Front brake pad sensors, under center column (Arguments), type: Br_v;100;31;255;255;8000h;Fh;FFh;FFh;00h Click Jobs menu and select Start Job Once Only (or just press F5) To reset Rear brake pad sensors, under center column (Arguments), type: Br_h;100;31;255;255;8000h;Fh;FFh;FFh;00h Click Jobs menu and select Start Job Once Only (or just press F5) That gives an error in Tool32 speechless Tried with ;;;;;8000h;;;;; - for writing only mileage - no luck. Is it a new DSC unit ? RE: CBS - brakes 255% E9x - d3lete - 22-01-2022 try reset with unplugged indicator, then connect again and try. if it doesnt work update your dsc module. RE: CBS - brakes 255% E9x - jaramillo - 22-01-2022 Have you tried to update DSC? RE: CBS - brakes 255% E9x - Darmand - 22-01-2022 Will try with disconnected wear indicators. Some say,- that a resistence of LESS than 1 Ohm should be in a new OK indicator. And you should try with wire jumper. Haven't programmed it - yet. New indicators from BMW has been ordered RE: CBS - brakes 255% E9x - GoNz0- - 22-01-2022 Been here before, you need to follow the other CBS correction vehicle data and enter the pad thickness. RE: CBS - brakes 255% E9x - bmchicago - 22-01-2022 add +KCBS to VO, manually program DSC, calibrate dsc sensors and encode vehicle. try to reset RE: CBS - brakes 255% E9x - Rooster330i - 23-01-2022 Hi, sometimes it is necessary to reset the KOMBI software via the service menu or diagnostics in order to be able to reset the wear indication. Technical Note: On some vehicles, the parking brake must not be applied to allow service intervals to be reset |