+- CarTechnoloGY (https://cartechnology.co.uk)
+-- Forum: Discussions All about Software and Hardware (https://cartechnology.co.uk/forumdisplay.php?fid=310)
+--- Forum: Automotive Help & Discussions / Software and Hardware (https://cartechnology.co.uk/forumdisplay.php?fid=40)
+---- Forum: Fiat - Alfa Romeo (https://cartechnology.co.uk/forumdisplay.php?fid=82)
+---- Thread: Solved ✔ MultiEcuScan + OBDLink (/showthread.php?tid=60855)
Pages:
1
2
MultiEcuScan + OBDLink - Liteace - 18-02-2022
I have MultiEcuScan and OBDLink, red cable that I use with renolink, does anyone use the MultiEcuScan + OBDLink together and if yes what are the results?
Thanks
RE: MultiEcuScan + OBDLink - pupu144 - 18-02-2022
I had it for some time.
Works great, very fast.
Some modules/cars require additional "coloured" adapters, which MES kindly reminds you about.
RE: MultiEcuScan + OBDLink - Liteace - 19-02-2022
Anyone know what adapter is needed to access body on Fiat 500 or has pinout
RE: MultiEcuScan + OBDLink - mattydr67 - 19-02-2022
(19-02-2022, 10:25 AM) Liteace Wrote: Anyone know what adapter is needed to access body on Fiat 500 or has pinout
To acces in some BCM you need adapter A3 and in other you don't need any adapter.
On multiecuscan[dot]net you have all 6 adapters schematic.
You also can check what adapters you have to use..
Good luck
RE: MultiEcuScan + OBDLink - Liteace - 23-02-2022
I cant get it to work, I think I need driver for OBDLink, anyone know where i can get it?
RE: MultiEcuScan + OBDLink - 5.1 - 23-02-2022
(23-02-2022, 22:00 PM)Liteace Wrote: I cant get it to work, I think I need driver for OBDLink, anyone know where i can get it?
Hi,
Did you try setting up your interface in settings..? Check attached screenshot...
Good luck,
Sébastien.
RE: MultiEcuScan + OBDLink - Liteace - 23-02-2022
(23-02-2022, 22:43 PM)5.1 Wrote:Yes, I changed settings but always have:(23-02-2022, 22:00 PM)Liteace Wrote: I cant get it to work, I think I need driver for OBDLink, anyone know where i can get it?
Hi,
Did you try setting up your interface in settings..? Check attached screenshot...
Good luck,
Sébastien.
"disconnected"
at the bottom left
RE: MultiEcuScan + OBDLink - fantomel - 23-02-2022
if u used it with renolink you need to use the set speed program and downgrade it's speed from 1 million to 115200. Check marketplace area, there is a tread with renolink and program is there provided to set the speed of your interface.
RE: MultiEcuScan + OBDLink - ocostel - 24-02-2022
Here you have the driver and utility software to change baudrate
RE: MultiEcuScan + OBDLink - Liteace - 24-02-2022
When I lower the baudrate I then have to put it back to what it was to use with Renolink again?