Solved ✔ Mercedes Vito W638 Start Error - Printable Version +- CarTechnoloGY (https://cartechnology.co.uk) +-- Forum: All About IMMO/ECU , ChiPTuninG , Dashboard , Locksmith , AirbaG , Carradio (https://cartechnology.co.uk/forumdisplay.php?fid=3) +--- Forum: IMMO & LOCKSMITH (https://cartechnology.co.uk/forumdisplay.php?fid=9) +--- Thread: Solved ✔ Mercedes Vito W638 Start Error (/showthread.php?tid=62469) |
Mercedes Vito W638 Start Error - Mshumacher - 26-03-2022 Hello old Mercedes vito W638, 2001 year or so, car no start. In cluster " Start Error " Message. I checked xentry diagnostic : WSP Values: Reading in of key is temporarily blocked => YES Key read in => YES Valid Key => YES Can Signal received MSG => No (F) Enable immobilizer (Valid Key) =>NO (F) MSG start enable (valid immobilizer)No (F) CDI 1 Values Engine control module identified NO Engine control module interlocked NO Start Enable NO WSP and engine control module compatible YES WSP control modules NO (F) CAN reception from WSP YES Engine control module or CAN bus YES CDI Receives from ETS/ABS/ASR YES CDI Receives from ETC NO CDI Transmits to ASR/ESP/Auto AC/ETC YES CDI Transmits to ASR/ETC/IC YES CDI Transmits to ETC/ASR YES CDI Transmits to IC/ASR/ETC YES CDI Receives from ETS/ABS => YES CDI Receives from IC => NO CDI Receives from IC => YES So All looks ok ?? In this cases "Start error" i remember i did one case a long time ago, where i read immo hc08 mcu, and eeprom on ecu. After that it wast just load the immo files into a program mb start error repair, it generated immo and ecu files. After that just write ecu and immo , and should start correct ? Also mcu hc08, mask 0JD66, no need security bytes correct ? Car is far away so would like to avoid going several times.... I attach files, original+ repaired Thank you RE: Mercedes Vito W638 Start Error - didi70 - 27-03-2022 hi; try this file and report , and good luck take here and rep;thk RE: Mercedes Vito W638 Start Error - Mshumacher - 05-05-2022 Sorry for late response, van started |