Toyota Dash - Printable Version +- CarTechnoloGY (https://cartechnology.co.uk) +-- Forum: All About IMMO/ECU , ChiPTuninG , Dashboard , Locksmith , AirbaG , Carradio (https://cartechnology.co.uk/forumdisplay.php?fid=3) +--- Forum: DASHBOARD (https://cartechnology.co.uk/forumdisplay.php?fid=10) +--- Thread: Toyota Dash (/showthread.php?tid=6479) |
Toyota Dash - nilsmaster - 14-09-2014 What Tool support Toyota Prius Plus to change KM on Dash? Thnx RE: Toyota Dash - Dash_Burner - 15-09-2014 (14-09-2014, 17:19 PM)nilsmaster Wrote: What Tool support Toyota Prius Plus to change KM on Dash? Digiprog is doing the job very good but you must remove the whole dashboard which is a bit hard job for this car Toyota Dash - nilsmaster - 22-09-2014 (15-09-2014, 13:37 PM)mpitsaxis Wrote:(14-09-2014, 17:19 PM)nilsmaster Wrote: What Tool support Toyota Prius Plus to change KM on Dash? Digiprog ori or clone? RE: Toyota Dash - pioan - 22-09-2014 Work with clone very good. I make a prius with digiprog 4.88 yanhua version with no problem! Toyota Dash - nilsmaster - 22-09-2014 (22-09-2014, 18:49 PM)pioan Wrote: Work with clone very good. I make a prius with digiprog 4.88 yanhua version with no problem! I need one for Prius Plus Hybrid If it posible to do that via obd or only on removed dash board? RE: Toyota Dash - pietje001 - 23-09-2014 Only remove dash RE: Toyota Dash - MinhCao - 15-05-2015 Remove the dash - desoldering the eeprom 93c46 or 93c66 - use the UPA to read the data - save the original data - use the ETSmart calculate the mileage - revise the data follow the result of ETSmart - program to the eeprom - solder the eeprom back to the dash - take the coffee . Enjoy it. RE: Toyota Dash - KevinX - 02-06-2015 What do you need to do a 04 prius? can you use the small clip to read eeprom? RE: Toyota Dash - Dash_Burner - 03-06-2015 (02-06-2015, 14:04 PM)KevinX Wrote: What do you need to do a 04 prius? can you use the small clip to read eeprom? Which programmer do you have ? RE: Toyota Dash - Carspro - 23-06-2015 There are 6 test pads on the board near the EEPROM , if you have Digiprog can solder 6 wires using st47 to program in circuit . |