(14-02-2019, 11:58 AM)eteodun Wrote:  Hi guys,

I need help please with correct file software for DSG7 unit VW Scirocco 1.4TSI year 2010.
The car was to lot of garages and seems that original software has been changed.
In this moment I have 0AM300048N sw ver 2155 (v0693z550AM___getriebe_DSG_Ob3z_sw.sgo)

Thanks in advance

Best regards

(17-07-2016, 03:37 AM)vagvag Wrote:  

(16-07-2016, 10:28 AM)homer79 Wrote:  

(16-07-2016, 05:10 AM)vagvag Wrote:  

(15-07-2016, 17:50 PM)homer79 Wrote:  Can i downgrade to that firmware with Odis-E and a good VAS with OKI Chip after VW forced me to update to the new shitty firmware?
Any advices?

Hi..........
On any UDS ecu you can update or to downgrade or even to interrupt during the flashing and to restart..........
So you can play with your car and with your ecu as you wish and with anything that you wish.........
Regarts........

Hey thanks for your answer.
I am not sure whether i already have an ECU with UDS protocol.
When i connect to my ECU with VCDS the connection type says "CAN" not "UDS". It is a Bosch EDC17 in a 2009 Audi A3 2.0 TDI
Also it is a .sgo file. As far as i understood .sgo files are not for flashing UDS ECUs but older ones.

Any more hints?

One more question. When i want to flash with ODIS-E what should be considered for safety? Put the batterie on an external charger and the Laptop also on external Power supply.. more things to consider?

Kind Regards

Hi again............
If your car is from the 'last' ones little before VAG released cars with UDS ecus then you cant to 'play' as i describe above........
The .sgo files correct they are not for UDS ecus......
You can still update or downgrade your ecu for your car with the Odis-E but you need to configure your Odis-E to allow you to make this........
About safety you must be sure that you have proper VAS5054A if we talking for clone head and of course good and stable charger in your car battery as you said.......
Good luck!!!!!!!!!
Regarts.........

(12-04-2019, 07:28 AM)Dee67 Wrote:  Hi, All
I have just installed VAS-PC on WIN7x64 from Fantomels collection (Thanks Fantomel) but I am unable to configure my VCX Nano (for Odis) interface with it.
I have successfully installed ODIS Engineering 8.2.3 and Odis 4.4.10 on other laptop (WIN7x64) and working with this interface.
Can someone help to configure my VCX Nano to work with VAS-PC.
Thanks in advance

(12-04-2019, 16:40 PM)vagvag Wrote:  Vas-Pc does not run and not works under 64bit....... Only under 32bit..........
Regarts........

(12-04-2019, 16:48 PM)apoelistas Wrote:  Does not work on win7 x32 only on XP.