+- CarTechnoloGY (https://cartechnology.co.uk)
+-- Forum: All About IMMO/ECU , ChiPTuninG , Dashboard , Locksmith , AirbaG , Carradio (https://cartechnology.co.uk/forumdisplay.php?fid=3)
+--- Forum: CHIPTUNING (https://cartechnology.co.uk/forumdisplay.php?fid=12)
+--- Thread: Looking dflash for M5/M6 MEVD 17.2.H (/showthread.php?tid=67215)
Looking dflash for M5/M6 MEVD 17.2.H - laso - 29-07-2022
Hi
I need dflash for M5/M6 series F10.
I have a problem with immo on one side bank.
I need compare my dflash with other dflash for MEVD 17.2.H.
I need dump for master and slave ECU.
RE: Looking dflash for M5/M6 MEVD 17.2.H - AZCKNCLLC - 30-07-2022
(29-07-2022, 19:24 PM)laso Wrote: Hi
I need dflash for M5/M6 series F10.
I have a problem with immo on one side bank.
I need compare my dflash with other dflash for MEVD 17.2.H.
I need dump for master and slave ECU.
Put dumps here I check for you
RE: Looking dflash for M5/M6 MEVD 17.2.H - laso - 30-07-2022
here dump.
I see ISN in three places.
I also have feeds from another ECU that was used in the M5 / M6 and there the ISN is repeated 6 times, but it is MEVD 17.2.8.
My ECU's is MEVD 17.2.H.
On one bank I have still error "manipulation EWS".
Even after replacing the ECU, the error is on one side
RE: Looking dflash for M5/M6 MEVD 17.2.H - AZCKNCLLC - 30-07-2022
[attachment=130774 Wrote:[attachment=130775] laso pid='546183' dateline='1659168864']here dump.
I see ISN in three places.
I also have feeds from another ECU that was used in the M5 / M6 and there the ISN is repeated 6 times, but it is MEVD 17.2.8.
My ECU's is MEVD 17.2.H.
On one bank I have still error "manipulation EWS".
Even after replacing the ECU, the error is on one side
same data on both sides.
RE: Looking dflash for M5/M6 MEVD 17.2.H - laso - 30-07-2022
So it should be ok? So what could be causing this error?
RE: Looking dflash for M5/M6 MEVD 17.2.H - AZCKNCLLC - 31-07-2022
(30-07-2022, 17:39 PM)laso Wrote: So it should be ok? So what could be causing this error?
Data looks okay so must be different problem. Did you try to reflash software? Also check all wiring between dme and fem/cas? If you swap dme on other side does dtc follow or stay?