+- CarTechnoloGY (https://cartechnology.co.uk)
+-- Forum: Discussions All about Software and Hardware (https://cartechnology.co.uk/forumdisplay.php?fid=310)
+--- Forum: Automotive Help & Discussions / Software and Hardware (https://cartechnology.co.uk/forumdisplay.php?fid=40)
+---- Forum: VAG Group (VW - Audi - Seat - Skoda - Bentley) (https://cartechnology.co.uk/forumdisplay.php?fid=55)
+---- Thread: VAS 6154 (VW6154 V1.0 PCB) CLONE BOOTLOADER & FIRMWARE (/showthread.php?tid=81698)
VAS 6154 (VW6154 V1.0 PCB) CLONE BOOTLOADER & FIRMWARE - Gecco - 31-07-2023
Hello Guys,
view years ago a bought this interface, and with my own fault it was bricked after a FW update (wrong FW usage). Now after years, i have an ST-Link V2 Programmer and i am able to communicate with ST Link utillities to the STM32F407 chip on it.
I tried to flash and it was successfull but still no function. I think i do not have the right flash files for this interface and missing bootloader.....
My questions are:
1. Who can supply me the relevant files (BOOTLOADER & FIRMWARE) to re-animate this interface?
2. Is it in general possible over ST-Link V2 Programmer ?
3. What should i do as steps in ST-LINK Utillities ?
I also figure out that the J3 Connector with 8 Pins has following connections: Top left to to right > VSS > SWDIO > CWCLK > VDD
Low left to right > VDD > NC > NC > VSS
Images in attachment...
Thank you all in advance
Kind Regards Gecco
RE: VAS 6154 (VW6154 V1.0 PCB) CLONE BOOTLOADER & FIRMWARE - dom92 - 27-08-2023
hello did you find a solution? because I have a VAS6154 with firmware 1.6.6 and I would like to upgrade it to 1.8.9. but with VXDIAG software it is impossible.
Thanks