F31 06/17 backup camera retrofit, not showing up in ESys - Printable Version +- CarTechnoloGY (https://cartechnology.co.uk) +-- Forum: Discussions All about Software and Hardware (https://cartechnology.co.uk/forumdisplay.php?fid=310) +--- Forum: Automotive Help & Discussions / Software and Hardware (https://cartechnology.co.uk/forumdisplay.php?fid=40) +---- Forum: BMW - Mini - Rolls Royce (https://cartechnology.co.uk/forumdisplay.php?fid=61) +---- Thread: F31 06/17 backup camera retrofit, not showing up in ESys (/showthread.php?tid=82317) Pages:
1
2
|
F31 06/17 backup camera retrofit, not showing up in ESys - Freddy1 - 17-08-2023 I´m having trouble retrofitting a backup camera on a F31 LCI from 06/2017, BMW ETK said it needs a TRSVC (retrofit kit 6621 2361833) It was wired just like the EBA said. Ground, FBAS, K-CAN1 was empty, so I pinned that in there. The fuse 154 in the back was already used, so I tapped it to the cable. But it is not showing up in esys and I´m kinda stuck here, I double checked the wiring over and over again. What could be wrong, does the FEM not support K-CAN1? TAL calculation didn´t show a FEM swap with 3AG. I appreciate any help, thank you RE: F31 06/17 backup camera retrofit, not showing up in ESys - Siki78 - 17-08-2023 You need icam not trsvc RE: F31 06/17 backup camera retrofit, not showing up in ESys - henkdejong - 17-08-2023 you need another fem. RE: F31 06/17 backup camera retrofit, not showing up in ESys - Freddy1 - 17-08-2023 (17-08-2023, 20:35 PM)Siki78 Wrote: You need icam not trsvc As already said, the official retrofit kit from bmw contains a TRSVC. Are you sure about FEM? ESys is not showing to change it. RE: F31 06/17 backup camera retrofit, not showing up in ESys - DEJMIEN - 17-08-2023 Do you have a picture of your FEM sticker, or at least pn? RE: F31 06/17 backup camera retrofit, not showing up in ESys - Freddy1 - 17-08-2023 I will show you tomorrow, thanks so far RE: F31 06/17 backup camera retrofit, not showing up in ESys - bimmerlab - 17-08-2023 check headunit type evo is icam check diagram for evo RE: F31 06/17 backup camera retrofit, not showing up in ESys - alexnaoumov - 17-08-2023 (17-08-2023, 22:13 PM)bimmerlab Wrote: check headunit type Why is evo icam? Signal comes in analog. Headunit doesnt give a damn about what module sends that analog signal. Even if its your old VCR player… Evo says nothing about what camera system is installed.. RE: F31 06/17 backup camera retrofit, not showing up in ESys - Siki78 - 18-08-2023 You need trsvc for 5DL but icam for reverse camera RE: F31 06/17 backup camera retrofit, not showing up in ESys - henkdejong - 18-08-2023 I also retrofitted an f31 LCI once. Then the TRVC module was also not found by ista. I don't think there is any K-CAN activity in the fem. |