+- CarTechnoloGY (https://cartechnology.co.uk)
+-- Forum: All About IMMO/ECU , ChiPTuninG , Dashboard , Locksmith , AirbaG , Carradio (https://cartechnology.co.uk/forumdisplay.php?fid=3)
+--- Forum: CHIPTUNING (https://cartechnology.co.uk/forumdisplay.php?fid=12)
+--- Thread: Touran EDC17C46 in limp mode. DPF+AdBlue Delete (/showthread.php?tid=82773)
Touran EDC17C46 in limp mode. DPF+AdBlue Delete - anass_f - 30-08-2023
Hi mates,
I have here a Touran on which I tried ECUDECODER and Davinci and a service of a tuner but without success.
I deleted the AdBlue and the DPF. I physically removed the DPF and the AdBlue ECU + NOx sensor.
The car is still in limp mode with no DTC except for a glow plug. After flashing those three flash mods when I pull the measurements blocs I see the DPF measured and calculated masses are both: 60g (which is high). I also see the engine torque value is limited by "smoke torque limitation" value while driving.
I reset the DPF values with the original flash and then flashed the mods, but still no joy.
If someone can please help with this car.
Thank you in advance.
I think I might have found the culprit. The DPF diff sensor shows a very high value and I tested it with a handheld tool and it confirms the reading. This means the exhaust pipe is clogged somewhere. Probably in the back silencer because I have physically removed the DPF.
I'll keep the thread updated once I confirm the findings.
RE: Touran EDC17C46 in limp mode. DPF+AdBlue Delete - hurricane - 31-08-2023
i have remove adblue dpf from same car with davinchi and work well....what tool you use?
RE: Touran EDC17C46 in limp mode. DPF+AdBlue Delete - wjgud123 - 31-08-2023
Hi.
- Make resets on original file,
- flash mod,
- disconnect Adblue module
- clear dtc
and leave feedback
pass via pm after rep+thx
RE: Touran EDC17C46 in limp mode. DPF+AdBlue Delete - ecumobile - 03-09-2023
It needs you to tell it that you have replaced the DPF, if it still doesn't react, you have to cancel the EGR mechanically.