Peugeot 407 transmission automatic - Printable Version +- CarTechnoloGY (https://cartechnology.co.uk) +-- Forum: Discussions All about Software and Hardware (https://cartechnology.co.uk/forumdisplay.php?fid=310) +--- Forum: Automotive Help & Discussions / Software and Hardware (https://cartechnology.co.uk/forumdisplay.php?fid=40) +---- Forum: PSA Group (Citroen - Peugeot) (https://cartechnology.co.uk/forumdisplay.php?fid=56) +---- Thread: Peugeot 407 transmission automatic (/showthread.php?tid=8329) |
Peugeot 407 transmission automatic - ucforstill - 21-06-2015 Hi i wash the motor of my car peugeot 407 ,it start , but doesn't move (depart) it writ in the dashbord D WHEN I CHANGE it write all rapport ,but doesn't move. when i did diagnostic it gave me fault code P0765 please help me RE: Peugeot 407 transmission automatic - killerbike - 21-06-2015 Shift solenoid(ss)D circuit mlfunction RE: Peugeot 407 transmission automatic - McMihai - 21-06-2015 (21-06-2015, 15:34 PM)ucforstill Wrote: Hi Possible causes - Low transmission fluid level - Dirty transmission fluid - Faulty shift solenoid 'D' valve - Shift solenoid 'D' valve harness or connectors - Shift solenoid 'D' valve circuit is open or shorted The P0765 code is detected when the ECM detects an improper voltage drop when it tries to operate the solenoid valve. Possible symptoms - Engine Light ON (or Service Engine Soon Warning Light) - Transmission will not shift gears P0765 Description Shift solenoid valve 'D' is turned ON or OFF by the Transmission Control Module (TCM) in response to signals sent from the park/neutral position (PNP) switch, vehicle speed and Engine Control Module (ECM) (throttle opening). Gears will then be shifted to the optimum position. RE: Peugeot 407 transmission automatic - tolis - 23-06-2015 (21-06-2015, 15:34 PM)ucforstill Wrote: Hi check the connector on gearbox if it is ok you have problem with gearbox RE: Peugeot 407 transmission automatic - MARTINS AUTOMECH - 13-08-2015 If you vehicle was working alright before washed,then it could be water had penitrated into the gearshift solonoid disconnect the harness and dry it ,if problem persist then change the gearshift solonoid afterwards hook pp2000or diagbox read and clear fault code then initialise autoadaptive |