G31 3AG retrofit issues with ICAM4 update - Printable Version +- CarTechnoloGY (https://cartechnology.co.uk) +-- Forum: Discussions All about Software and Hardware (https://cartechnology.co.uk/forumdisplay.php?fid=310) +--- Forum: Automotive Help & Discussions / Software and Hardware (https://cartechnology.co.uk/forumdisplay.php?fid=40) +---- Forum: BMW - Mini - Rolls Royce (https://cartechnology.co.uk/forumdisplay.php?fid=61) +---- Thread: G31 3AG retrofit issues with ICAM4 update (/showthread.php?tid=84415) |
G31 3AG retrofit issues with ICAM4 update - Carservice345 - 15-10-2023 Hello together, I retrofitted the rear view camera on a G31 today, the camera is connected to the BDC. First I changed the vehicle order +3AG, coded BDC, ACSM, HU and injected CAFD from the ICAM4. The camera works fine and there is nothing in the error memory. I tried to update the camera with E-Sys and got this message: Switching to programming mode was not successful for: ICAM4_0x06 [WARNING]. Topology error: ECUid: ICAM4_0x06 is not accessible because the ECU cannot be switched to programming/encoding mode. When I try to read out the SVT I also get Ethernet errors :-/ Till now tried with: S15A-22-03-530 E-Sys 3.30, 3.38 and 23.04.00 and PSdZData_4.39.30 Vehicle I-Level: S15A-22-03-530 Best regards. RE: G31 3AG retrofit issues with ICAM4 update - Siki78 - 15-10-2023 If you try to update with enet my friend had same problem and I falsh successfully with enet+dhcp server RE: G31 3AG retrofit issues with ICAM4 update - Carservice345 - 15-10-2023 (15-10-2023, 17:17 PM)Siki78 Wrote: If you try to update with enet my friend had same problem and I falsh successfully with enet+dhcp server I have already tried to flash with ENET cable and ICOM Next directly connected to my laptop, unfortunately without success. Will flash the days with latest psdzdata and enet+dhcp server. The question is, why do I get the error when I try to read VCM? Read (ECU) works fine RE: G31 3AG retrofit issues with ICAM4 update - Siki78 - 15-10-2023 You can`t read vcm just read ecu RE: G31 3AG retrofit issues with ICAM4 update - RaoulK1998 - 16-10-2023 disable programming mode in tal execution and try again |