Nissan Terrano II 2002 - P1612 "CHAIN OF ECU-IMMU" - Need immo off (?) - Printable Version +- CarTechnoloGY (https://cartechnology.co.uk) +-- Forum: Discussions All about Software and Hardware (https://cartechnology.co.uk/forumdisplay.php?fid=310) +--- Forum: Automotive Help & Discussions / Software and Hardware (https://cartechnology.co.uk/forumdisplay.php?fid=40) +---- Forum: Renault - Dacia - Nissan - Infiniti (https://cartechnology.co.uk/forumdisplay.php?fid=57) +---- Thread: Nissan Terrano II 2002 - P1612 "CHAIN OF ECU-IMMU" - Need immo off (?) (/showthread.php?tid=85648) |
Nissan Terrano II 2002 - P1612 "CHAIN OF ECU-IMMU" - Need immo off (?) - roanoke - 17-11-2023 Hi FRIENDS I have problem with Nissan Terrano II 2002 2.7 TDI. I have the following errors in ECU: P1612 "CHAIN OF ECU-IMMU" P1610 "LOCK MODE" The engine does not start. I do not have a Security Card for Nissan Consult. I can only read errors from the engine controller. I performed the following procedures: - have been done, the car still won't start. And now I don't know where to look for a solution to the problem - should I do IMMO OFF (if so, how to do it? Read the eeprom? - perform some synchronization? But how? What device? - replace NATS? - replace ECU (bosch edc)? - BCM? I only have one key. This indicator, when the ignition is on, sometimes comes on and sometimes goes off. With the ignition off and the doors closed, this light behaves normally. I have devices: - nissan consult 2 (software without security card) - SVCI2020 - CK100 Key Programmer tool - Lonsdor key programmer tool I don't know the synchronization option anywhere Any ideas? |