Help icam2 on f44 - Printable Version +- CarTechnoloGY (https://cartechnology.co.uk) +-- Forum: Discussions All about Software and Hardware (https://cartechnology.co.uk/forumdisplay.php?fid=310) +--- Forum: Automotive Help & Discussions / Software and Hardware (https://cartechnology.co.uk/forumdisplay.php?fid=40) +---- Forum: BMW - Mini - Rolls Royce (https://cartechnology.co.uk/forumdisplay.php?fid=61) +---- Thread: Help icam2 on f44 (/showthread.php?tid=86999) Pages:
1
2
|
Help icam2 on f44 - giando11 - 26-12-2023 Hi can anyone help me with reverse camera reteofit?i've buy an f44 original reversing camera icam2-r. Can anyone say me wich wire i've to buy? Same as g30 g31? Do you have a code? There is a link to the instruction? Thank you RE: Help icam2 on f44 - Pommie - 26-12-2023 giando11 dateline='[url=tel:1703576196' Wrote: 1703576196[/url]'] You don’t give a lot of information but here’s a basic wiring diagram, you have to see what equipment your vehicle has and work it out from there. There’s plenty of cheap aftermarket looms that you can use/modify but I don’t know of an OEM solution without a lot of research. RE: Help icam2 on f44 - giando11 - 26-12-2023 Mmm i'm not sure wich wire i buy for my car RE: Help icam2 on f44 - Pommie - 26-12-2023 Again, you haven’t supplied any useful information on your vehicle. They don’t make a specific OEM loom so I would buy something for the G20/30 (Ethernet loom) and modify it according to your wiring diagram. EBay is the easiest place to look, attached are the G30 fitting instructions, there is none available for the F44. RE: Help icam2 on f44 - giando11 - 27-12-2023 Ok how i check if i have ethernet seitch or not? RE: Help icam2 on f44 - Pommie - 27-12-2023 giando11 dateline='[url=tel:1703661197' Wrote: 1703661197[/url]'] Check here depending on drive side … RE: Help icam2 on f44 - Node - 27-12-2023 Either do manual check or give here your vin. It can be checked then by vin. RE: Help icam2 on f44 - giando11 - 27-12-2023 WBA31AM0307J13553 this is my vin RE: Help icam2 on f44 - Node - 27-12-2023 Your car does NOT have ethernet switch. RE: Help icam2 on f44 - Bimbo666 - 27-12-2023 Hello, I use this! |