+- CarTechnoloGY (https://cartechnology.co.uk)
+-- Forum: Discussions All about Software and Hardware (https://cartechnology.co.uk/forumdisplay.php?fid=310)
+--- Forum: Automotive Help & Discussions / Software and Hardware (https://cartechnology.co.uk/forumdisplay.php?fid=40)
+---- Forum: BMW - Mini - Rolls Royce (https://cartechnology.co.uk/forumdisplay.php?fid=61)
+---- Thread: G Series KEY in F34 (/showthread.php?tid=90278)
G Series KEY in F34 - Rajco - 19-03-2024
does anyone have an idea?
A customer had a G key made for his F34.
the key also has 315MHz.
I read out his FEM with Bimtool Pro and the key was programmed as a 3rd key.
Everything looks good too.
But he can only start if he holds the key to the steering column, but cannot lock and unlock the doors with the remote controle.
I thought his key was defective so I took another key with 315Mhz and just re-soldered the chip. same result
I have already made a few keys, but only with CAS and not with FEM
Any idea?
RE: G Series KEY in F34 - gabur431 - 20-03-2024
Try to program a NEW Key with 315Mhz on 4th place
RE: G Series KEY in F34 - RuleNormaliai - 20-03-2024
delete that 3rd key and program it again simple by holding key near the steering column and turning ignition on.
it happens sometimes with FEM/BDC cars.
RE: G Series KEY in F34 - Rajco - 20-03-2024
(20-03-2024, 15:06 PM)RuleNormaliai Wrote: delete that 3rd key and program it again simple by holding key near the steering column and turning ignition on.
it happens sometimes with FEM/BDC cars.
Delete over OBD?
RE: G Series KEY in F34 - RuleNormaliai - 20-03-2024
yes, as FEM is already locked, no need to remove it, you can do that over OBD
RE: G Series KEY in F34 - Rajco - 20-03-2024
(20-03-2024, 18:22 PM)RuleNormaliai Wrote: yes, as FEM is already locked, no need to remove it, you can do that over OBD
I imagine that Bimtool wrote that it had to be programmed when I connected. It could be that I'm imagining it