Programming KOMBI and NBT fails on F series - Printable Version +- CarTechnoloGY (https://cartechnology.co.uk) +-- Forum: Discussions All about Software and Hardware (https://cartechnology.co.uk/forumdisplay.php?fid=310) +--- Forum: Automotive Help & Discussions / Software and Hardware (https://cartechnology.co.uk/forumdisplay.php?fid=40) +---- Forum: BMW - Mini - Rolls Royce (https://cartechnology.co.uk/forumdisplay.php?fid=61) +---- Thread: Programming KOMBI and NBT fails on F series (/showthread.php?tid=9162) |
Programming KOMBI and NBT fails on F series - Cybertronic - 01-08-2015 Does anyone else have issues when updating an I level on a F (F22 specifically) ? NBT and KOMBI always fail. I'm using an ICOM to connect to the car. I can flash them fine with E-Sys. If I'm doing something wrong I would love to know RE: Programming KOMBI and NBT fails on F series - IZGOY - 01-08-2015 Only ENET cable! RE: Programming KOMBI and NBT fails on F series - kjysda - 01-08-2015 (01-08-2015, 04:51 AM)Cybertronic Wrote: Does anyone else have issues when updating an I level on a F (F22 specifically) ? me too. I have a same problem NBT & KOMBI.(F3X) RE: Programming KOMBI and NBT fails on F series - KaiO - 01-08-2015 ISTA P 3.56 is very buggy. See release notes for known errors RE: Programming KOMBI and NBT fails on F series - ap535d - 01-08-2015 It is a fault in ISTA/P. RE: Programming KOMBI and NBT fails on F series - KaiO - 01-08-2015 I think BMW will soon rollout a major version (3.57) which solve these errors, since many workshops have serious problems with this release. RE: Programming KOMBI and NBT fails on F series - winter - 01-08-2015 I've tried several times for F01,F10,F30,programming by ISTA-P 3.56.0,3.56.1 and 3.56.2 with ICOM A and BMW ISSS or ISTA-P loader 4.1,same problem happened as only MOST modules for example HU-H,Kombi,RSE were failed,Action list displayed "missing prerequisites for action".but entire ilevel already was updated. To version 3.56.3.002,this issue didn't be solved. Programming KOMBI and NBT fails on F series - ruben_17non - 01-08-2015 Yea just ENET or use Router for DHCP IP for Icom. RE: Programming KOMBI and NBT fails on F series - hulahans - 01-08-2015 No need for physical router, you can also use this tool emulating a router, works for me over some month with ista p NBT and kombi http://www.dhcpserver.de/cms/ RE: Programming KOMBI and NBT fails on F series - SweetBMW - 01-08-2015 So if i connect the icom to an F25 through a router, it should be fine updating the car? Or should i use an enet cable directly? |