[MR2CHIPS]

Hi, can you help with a problem 2005 design 3 door citroen c2 1.4hdi engine.

Bought car as a non runner engine turning over not starting. found the abs ecu had burnt up and damaged the car engine ecu.
now this is where the problem is, tried to clone the engine ecu but the 95160 eeprom has been corrupted by whatever happened with the abs ecu frying! therefore no information can be extracted off the ecu. (Took ic 95160 off board to check data so I know its damaged)the can bus ic inside the car engine ecu was also damaged.
is there a full virgin dump of the eeprom 95160 for a bosch edc16c34 or some method of getting a full bdm dump onto another ecu edc16c34?
which software would a person use to flash a whole ecu and not just the eeprom,
eeprom is the easy part.(i have a SPI programmer that can read/write 95160)

any help would be appreciated thanks

Ecu number: 028 1011 785 edc16c34
The original flash/95160 eeprom I require(virgin or immo off)
And which programme/software to use to read/write the flash via CAN bus/K-line if possible

PS (Any working flash dump/eeprom off a C2 Bosch edc16c34 1.4 hdi would be helpfull)

Thanks