[Ecutech]

Hello all, 

I rarely come on here asking for help, but this job is making my hair go grey....FAST!

I had the dreaded P062F DTC, as well as water ingress into the ecu. 

I have repaired the ecu and re-flashed with TECH2 van now starts fine.

Problem now is that I am unable to program the injector codes. I gain security access in TIS, I write the new codes, cycle the ignition and ends up with programming failed. Interestingly, if i leave the codes as AAAAAAA the programming is successful. 

I have adapted all the other configurations through TECH2 with security access so i doubt its a hardware problem.

Can somebody either give me the address for the injector codes, or enter them for me. I will love you forever.

INJ1-BSSIE5H 

INJ2-AR1F31G

INJ3-7ZZR1IH

INJ4-AAAB5WG

Thank You for your help.

[darek_naprawa]

Use galletto or mpps.

---

Injector codes are in flash,

[Ecutech]

Use galletto or mpps.

---

Injector codes are in flash,

I thought i attatched both. Sorry. Will upload it now

[sisco]

try one code at a time

[Ecutech]

Solved by inputing the codes manually in the flash file with hex editor. Wake up error with hq kess. Galletto wrote the codes but on cycle of the ignition they were lost and showed as aaaaaaa again.