[Liveros]

Hi to everyone, glad do be here

I only need some thing if u can help me ...
I found some procedures about a full method of cas4 and f10 mileage correction but still i didn t understand very much ...
Tommorow i will have a car with this "problem"... customer in past mounted a start kit (dme-elv-cas-etc), because old dme was burned(water issue)

I have vvdiprog to read this cas !

Can help me some one with a full read/write procedure of cas and also the dash ? and also correct method of do this?
With which kind of software i can reset cas to 0 km?

Thx in advice ... i give a big big beer

[pepi]

Read CAS4 and save Dflash and Pflash, reset SEC on MCU ,read Dflash upload dump here if you dont have any calc .