[sulibrk]

So the clone file - same. car does not start, glow plug blinking but now, there is no message about immo on dash.

btw - here is EDC15+ read by OBD.

By diag, there is no error on 17 neither 25

In 25 I see correct VIN and IMMO ID but in ECU i see error - engine start blocked by immobiliser

Error code in ECU is : P1570-35-10

Also, radio wants PIN that I do not have

[evg_eni]

Hm, everything looks ok on your screenshot (about immo), only problem is that new cluster for some reason not comunicate with car ecu, therefore maybee you got error on channel 50.
I will look again on files, but maybee some adaptation is necessary, check adaptation channels on 17instruments, or maybee some wiring work. Radio wants code because cluster keep radio sync data, you must have code to unlock the radio with new cluster or maybee i can found where is sync data located on your old eeprom.

[sulibrk]

I went through all codings, adaptations etc... everything is coded properly, so I am not really sure what is a problem here with this one crap... Most annoying thing is - it is for my sister, so I am literally wasing both mine and your time chasing this strange situation.

I tryed turning off immo in 01-ECU and its ok, no error on dash... i would call it ok.

Only thing is a radio, is it possible to get the code or anything else to make it working?

[evg_eni]

i told you, cluster is adapted but not "speak" to ecu. when comunication is ok, car will start, you can try to recode can gateway, keep same coding and just save without changes. Are you sure cluster is fully working now, tacho ,speedo etc..? If you want to keep immo off, then only radio sync data problem must be solved. it may be on many locations, if someone know exactly where is located i can transfer it to your new cluster, otherwise we will need to make many write attempts (experiments) until we found right location.

[sulibrk]

Yep, tryed with coding to gateway. No change.

Will Go for a test drive to see all is ok.