Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
NBT EVO retrofit working....almost fine...
22-02-2018, 19:43 PM,
(This post was last modified: 22-02-2018, 19:46 PM by emhtuning.)
Post: #11
|
|||
|
|||
RE: NBT EVO retrofit working....almost fine...
the guys already gave you many solutions to try , did you check it out , specially the coding part of the NBT EVO ?
Edit : follow my instructions regarding the Controller wiring , then check if you will have the cluster issue . |
|||
22-02-2018, 20:35 PM,
Post: #12
|
|||
|
|||
RE: NBT EVO retrofit working....almost fine...
(22-02-2018, 19:43 PM)emhtuning Wrote: the guys already gave you many solutions to try , did you check it out , specially the coding part of the NBT EVO ? As I have already written in previous posts, Yes, I had already done the suggested coding, that's why it ...occasionally... works. I will try the proposed wiring and post back the results. Thanx everyone. |
|||
22-02-2018, 22:54 PM,
Post: #13
|
|||
|
|||
RE: NBT EVO retrofit working....almost fine...
And surprise-surprise, I discovered another problem.
When the afforementioned issue occurrs, HU is not detected at all by ESys (no HU in SVT when I hit Read SVT ECU). It can only be detected if I disconnect-reconnect the battery and until the controller stops working properly (after some time...). Would it be wrong to assume that there must be a problem with the emulator? |
|||
« Next Oldest | Next Newest »
|
Users browsing this thread:
1 Guest(s)
1 Guest(s)
Return to TopReturn to Content