[Kenny]

Hi
I am a newbie with Galleto, i have Chinese clone version 54.
I want to read a PSA IAW 6LPB ecu. ST10F280

In manuals i have Type B, so:
B1 = K-Line
M1 = GND
L4 = +12v
I have connected the resister its not exactly 100 ohm but 99.3 ohm

I'm using the Renases cable.
the green wire goes to pin 8 of Galleto - everywhere says green is K-line.
Is this correct?
On the other cable with Can wires the green wires go to pin 7 and that looks like ignition.

When i try read it gives me error :
Send info for help and Boot mode inactive.

Must the resister be 100 ohm exactly?
Is pin 8 green wire K-Line?

Thanks

[Kenny]

I Have solved my problem.
The ignition wire is K-Line.
K-Line is 12volt communication.