[bmw_mads]

Hi all.

I am trying to read out a edc17cp60 gpt so fare no luck
I tryed with ktag 0720. I have tryed to use the bootpin nr6 as descripe in connection. Allso tryed cmd connection.

So maby ktm100. Will read it. So is there a frendly saol that can share. I realy like to read it.
Thx in advance

[rs@chip]

Hi all.

I am trying to read out a edc17cp60 gpt so fare no luck
I tryed with ktag 0720. I have tryed to use the bootpin nr6 as descripe in connection. Allso tryed cmd connection.

So maby ktm100. Will read it. So is there a frendly saol that can share. I realy like to read it.
Thx in advance

mate I try this ecu with original cmd and ktag not a chance to read password..If ecu is original state than maybe but if car was tuned before or any mods are done on ecu only x17 can read it..strange but true..for trasdata migration kit I have only for 6.070 firmware for newer I dont no If work never tryed..good luck

[bmw_mads]

Thx for replai

Its not tuned. But i will try to buy a grapper smd and use desind connection on pin 6. Only tryed to reach by a pin and cmd boot pin out and no luck. But i will report when i done and have spare time.

[skywoker]

Here is ktm100 software and firmware.
Link will work 48 hours. Enjoy!