[tutuianu_daniel]

on sticker is written ECE, so I think is a genuine ECE

[maksymw]

I checked but there is not such an option.

on sticker is written ECE, so I think is a genuine ECE

Read FDL HU_NBT2, find and change:

SDARS_MODUL to gen_4.5

RADIO_SDARS to nicht_aktiv


It will solve your problem and the error will disappear.

[tutuianu_daniel]

RADIO_SDARS was already nicht_aktiv, I just changed SDARS_MODUL to gen_4.5
the error was still present

after that I ran again ABL "Head Unit: General Faults"
the error is still present

Code:

F_ORT_NR = 12056796
F_HEX_CODE = B7,F8,DC,68
F_ORT_TEXT = SDARS Transportmodus aktiv
F_READY_NR = 16
F_READY_TEXT = Testbedingungen erfüllt
F_STATUSBYTE = 104
F_WARNUNG_NR = 128
F_EREIGNIS_DTC = 0
F_VORHANDEN_NR = 72
F_WARNUNG_TEXT = Fehler würde kein Aufleuchten einer Warnlampe verursachen
F_VORHANDEN_TEXT = Fehler gespeichert

---

---

I checked but there is not such an option.

Use rheingold. Calculate the test plan or search for ABL "Head Unit: General Faults". I did it myself. It works.

CLUE:

I found that nbt.prg has a job "steuern_fix_sdars_transportmode_off" with comment : "Test job based on repair.sh" but this job is not present in nbtevo.prg file. If I run "steuern_fix_sdars_transportmode_off" from nbt.prg to a NBT EVO the result is:

JOB_STATUS = ERROR_ECU_INVALID_KEY
_RESPONSE_0 = 71,01,FD,EE,36

[tutuianu_daniel]

CLUE:

I found that nbt.prg has a job "steuern_fix_sdars_transportmode_off" with comment : "Test job based on repair.sh" but this job is not present in nbtevo.prg file. If I run "steuern_fix_sdars_transportmode_off" from nbt.prg to a NBT EVO the result is:

JOB_STATUS = ERROR_ECU_INVALID_KEY
_RESPONSE_0 = 71,01,FD,EE,36

any ideas ?

[tutuianu_daniel]

I downgraded firmware to 4.10.13 and the error disappeared.