[Arg0N]

Hello. Just fitted lm2 into prefl e61 and got lci tail lights. Anyone know how to code out that bulb to 0v in lma? Photo attached

[emhtuning]

full coding for PRE LCI E60 with LMA2 + LCI taillights , check and compare these values with yours

KALTUEBERWACHUNG_BLK_H_L
nicht_aktiv
KALTUEBERWACHUNG_BLK_H_R
nicht_aktiv
WARMUEBERWACHUNG_BLK_H_L
nicht_aktiv
WARMUEBERWACHUNG_BLK_H_R
nicht_aktiv
KALTUEBERWACHUNG_BL_L
nicht_aktiv
KALTUEBERWACHUNG_BL_R
nicht_aktiv
KALTUEBERW_RL_BL_1_L
nicht_aktiv
KALTUEBERW_RL_BL_1_R
nicht_aktiv
WARMUEBERW_RL_BL_1_L
nicht_aktiv
WARMUEBERW_RL_BL_1_R
nicht_aktiv
WARMUEBERWACHUNG_BL_R
nicht_aktiv
WARMUEBERWACHUNG_BL_L
nicht_aktiv
RL_BL_PARKL_FKT
nicht_aktiv
BL_2_PARKL_FKT
aktiv
PWM_ANSTEUERUNG_BL
wert_02
PWM_ANSTEUERUNG_RL_33
wert_04
RL_BL_1_PARKL_FKT_33
aktiv

[Arg0N]

RL_BL_PARKL_FKT
nicht_aktiv
BL_2_PARKL_FKT
aktiv
RL_BL_1_PARKL_FKT_33
aktiv

These 3 were different, but stil its the same... I know its possibld because it was done once

[hashtagmaster]

RL_BL_PARKL_FKT
nicht_aktiv
BL_2_PARKL_FKT
aktiv
RL_BL_1_PARKL_FKT_33
aktiv

These 3 were different, but stil its the same... I know its possibld because it was done once

coding back to factory (with empty .MAN file) - then again as emhtuningsaid

[emhtuning]

RL_BL_PARKL_FKT
nicht_aktiv
BL_2_PARKL_FKT
aktiv
RL_BL_1_PARKL_FKT_33
aktiv

These 3 were different, but stil its the same... I know its possibld because it was done once

offcourse its possible , I personally have done this retrofit at least on 50 E6x during the past 10 years with LM2 and LM1 as well  and the coding list I mentioned earlier is the correct coding for E60 also I remember one friend did on E61 and was almost the same coding .

as hashtagmaster  said , do default coding with 0906 ( PRE LCI with LM2 from factory ) and 0908 ( LCI ) production date  then compare both coding trc files and see which one fix your issue .

the whole idea of fitting LM2 is when retrofitting LCI Headlights , LCI taillights are easy to retrofit with the simple LM1