[mcrussell]

Hi Guys,

Has anyone come across this issue?

2015 F30 335d, car has 6WB Retrofitted, & native ID4 Evo flashed to ID5.

I created a TAL in eSys to update the DDE using the original FA, successfully flashed the DDE & EGS, however afterwards the KOMBI has stopped communicating in esys & ISTA.
KOMBI is still alive & working but unable to communicate from a diagnostic point of view.
I have flashed the FEM BODY & FEM GW to see if it will start communicating but no difference.
MOST is good as HK Amp & HU work OK with sound.
I have tried a 6WA cluster but that doesnt communicate either.

Has anyone come across this before?

[Semi14]

try to calculate svt_soll and save in VCM as SVT_Target

[mcrussell]

Thanks for the reply, Sorry I dont quite follow, I have a calculated SVT_SOLL which shows it requires D_KOMBI, so can I save that to the car?

[Semi14]

In esys you have the vcm tab. Find svt target and save your svt soll

[Siki78]

Thanks for the reply, Sorry I dont quite follow, I have a calculated SVT_SOLL which shows it requires D_KOMBI, so can I save that to the car?

Because you write 6WB in your FA even your car is not compatibel with this SA option. Remove 6WB from FA and tick in esys settings "update VCM after TAL calculation" then VO code ZBE or any other module. Ater that read ecu again

[mcrussell]

Thanks for the reply, Sorry I dont quite follow, I have a calculated SVT_SOLL which shows it requires D_KOMBI, so can I save that to the car?

Because you write 6WB in your FA even your car is not compatibel with this SA option. Remove 6WB from FA and tick in esys settings "update VCM after TAL calculation" then VO code ZBE or any other module. Ater that read ecu again

Thanks Guys,

I will try that tomorrow & report back

[mcrussell]

Guys,

Just want to say a BIG thanks for your help, removed 6WB added 6WA, Wrote VCM & MSM to car & cluster appeared!!

Really Appreciated