[beemerboy88]

Thank you so much to beemerboy88 for your help

I have a OPS, so I interest in how to set vmware.

My OPS ip address is 192.168.68.22

I need a solution using my OPS for ISTA-P.

Thank you again.

Regard.

Sorry, I have no time to create new snapshots. Maybe have a look at icom emulator v3.1 & 2.50.2 package. You should be able to enter your OPS ip address into the icom connector & use it with ista/p 2.50.2.

http://garage-automotive.com/showthread.php?tid=3232

[maarhyna]

Because he doesnt have the dongle and it is me who has created the snapshot

[beemerboy88]

Because he doesnt have the dongle and it is me who has created the snapshot

Of course I have the dongle. Check my English v2 snapshots which are completely different & has ops for clone which you didn't provide.

[maarhyna]

Bimmertool you know?
in bmwcoders i give it and after you post it in all forum !!!!!!
if you want i post copy of your private message
i stop the message
i dont play

[beemerboy88]

Bimmertool you know?
in bmwcoders i give it and after you post it in all forum !!!!!!
if you want i post copy of your private message
i stop the message
i dont play

Sir, Are you serious?

I have the dongle.

[maarhyna]

I have the same sorry
im not a fool !!!!

[markolino]

Hi guys,
i've need only a software to view mechanical schematics and maintenance, like WIS or ElsaWin.
Which software i have to download for BMW ?

Thanks in advance!

[maarhyna]

ETK or realoem.com

[ap90500]

I can't get my cloned icom to work with this. Icom is updated to 3.10.44. I'm using Beemerboy88's english snapshots. Network setting are like they were in snapshots: Adapter one connected and bridged, adapter two not connected. Connection manager shows ICOM1120134, MAC 00:01:a9:00:ee:e9, VIN WBAMW91070xxxxxxx (my car's VIN), status red "cannot be used". Is MAC adress my problem? Any solutions? Thanks!

Solved. I changed to original russian snapshots, no solution. Then I read this topic once more and changed network settings: Adapter 1 -> connected and bridged, adapter 2 -> connected and host only. Adapter 2 had to be done through VMnet1 because it could not be set to connected and host only directly.

During installation I chose "I moved it". Is this the reason why those settings were not correct?

[markolino]

ETK or realoem.com

is it multilanguage or only english/ german?

thanks a lot.
Mark.