[m3nt4l]

Hi,

I have a 2013 Peugeot 508 showing the following faults:


B140A - of the fired Pretensioners
B1415 - Detection of rear impact
B0072 - Passengers pretension line fault
B0070 - Drivers Pretensioner fault

Just wondering if resetting the module would remove the codes and where the module is located.

Any help is appreciated

Thanks

[CHIKODIAG]

hi
1/ you need a clear the airbag ecu from crash data
2/ chaaenge the bad elemnt
3/you get the system without fault

[m3nt4l]

hi
1/ you need a clear the airbag ecu from crash data
2/ chaaenge the bad elemnt
3/you get the system without fault

Hi,

thank you for that information. if I read the crash data from the module using carprog can I write it via carprog also? can I post dump here for someone to clear the data? thanks

[CHIKODIAG]

hi
i dont know aubot carprog if you have a good clone i think it will do it
for the clear yes read and post here and you will get the help
good luck

[m3nt4l]

hi
i dont know aubot carprog if you have a good clone i think it will do it
for the clear yes read and post here and you will get the help
good luck

Thank you. Can I read direct from board or do I need to desolder then read?

Thanks

[CHIKODIAG]

hi
the beter is desolder then read to get a good data read
good luck