[emerer]

Hey guys

Is it possible to update "HN+_EU_AU_P0065" to Firmware 900 and then install 6.22.4?
i have read its older hardware and not possible.

[audia4]

Hey guys

Is it possible to update "HN+_EU_AU_P0065" to Firmware 900 and then install 6.22.4?
i have read its older hardware and not possible.

This MMI is old version 9410. I think the last version firmware for 9410 HN+_EU_AU_P0066_(A8)

[rafalcyna]

Hi All

I am preparing for map update in my A6 C7 with 3GP MMI. I have installed all MMI software updates one by one from factory one (with letter P) to K900. I have map ready to install on 32 GB sd card and also have second sd card ready with activation files, but I have problem with Xcode calculators.
My MAC address taken from from green menu is 001XX7226679, because of the last two digits in this MAC I have different results in different calculators: one made in excel gives 4267 because it does not take those last two digits in calculation. Another made by DarkDll (big thx) gives me 228680.

Can you help please which I should use?

Thx

Raf

[CEauto]

I don't think that is the correct MAC....a MAC cannot have 'X' in it, unless you are hiding some digits?

But I think the answer is 228680.

[rafalcyna]

Yes I am hiding two letters orginal is 001cd7226679 I will try to check MAC by other software and device connected to car`s WLAN. Can i try to use both codes for activation or wrong one will brick my MMI ?

[szefu55]

Hey guys

Is it possible to update "HN+_EU_AU_P0065" to Firmware 900 and then install 6.22.4?
i have read its older hardware and not possible.

that update will kill your mmi , there is a way to update without "curraption detected" but not for free

[no2]

Thanks a lot to darkdll and Harigami,

I have an Audi Q3 from 2013 with Bose with 3GP with HN+R_EU_AUP0660 and R00608884BC ECE 6.16.3.

Following the update instructions pdf, I finally update the firmware to K_0900 (with a Transcend SD XC I 64Gb card, read 95 mb/sec and write 60mb/sec) in 30 minutes, the map to 6.22.4 in 1 hour and 15 minutes and the Keldo activator in 10 seconds.

I only want to contribute to explain that does not appear any problem with Bose doing a standard update, but I have to say that the Activator only run when I put the Sd card in the slot number 2. When I put in the first slot anything happens.

Best regards

[Westyfield2]

FSC Remove if 03623 Fault

Thanks...
How does this work?
And does anything need redoing afterwards?

[CEauto]

As I understand it, the new activator does not need an FSC at all. I believe that the old map which you still have installed is also looking at the new (not required) FSC and saying it is invalid. So if you remove the FSC, the error goes away.

I deleted the old map on mine first though, so cannot answer the other questions...

[ginos]

I can not load the map 6.22.4 in an A7 with MMI 3GP whit software K900, a question mark symbol appears in the line of the map. someone can tell me what that symbol means and how it can solve?

Thank you