Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
VVDI PROG Support/Feedback Thread
04-01-2018, 22:14 PM,
Post: #151
|
|||
|
|||
RE: VVDI PROG Support/Feedback Thread
(04-01-2018, 08:56 AM)Xhorsesupport Wrote: Firstly,connect the device to the pc,obverse the led light,the red led should light always,the yellow led should blink.if the yellow led doesn't blink,you should change a usb port or pc to have a try. i tried on other pc but same issue only red light is on ,, the yellow one not blink USB Cable and drivers are ok .. because i can detect my SN and fw version Please help Appreciated BEST CHIPTUNING SERVICE BY Zenter Performance
Contact Skype: zenter-88 Facebook: https://www.facebook.com/ZenterPerformance -------------------------------------------------------------------------------------------------------------- highest Quality ChiPTuninG Files BY PTF Team https://performance-tuningfiles.com/ POWER BY TECHNOLOGY -------------------------------------------------------------------------------------------------------------- BEST CHIPTUNING SERVICE BY Jurebv Contact Skype: live:jure.coric_1 https://files.tuning-makarska.com/ -------------------------------------------------------------------------------------------------------------- - IMMO/ECU , ODO , AIRBAG , CARRADIO , TESTED SOLUTIONS UNDER MY SOFTWARE In progress TUNING STAGE1/DPF/SCR/EGR/TVA/FLAP/ START STOP OFF Software WHAT'S NEWS ! -Steering Angle Sensor Restore For LEXUS,TOYOTA,SUBARU,MITSUBISHI,VAG -Citroen DS5 Steering lock Renew/Write Code by dumps -Passat CCM Repair corrupted dump succes -VAG ECU SIMOS PCR 2.1 KM WITH CRC CORRECTED ! -IMMO OFF For NISSAN/INIFINITI with HITACHI ECU | CPU SH705X -Dacia Dashboard with Fujitsu MB96F6A6 Change km/Block Synchro Dash-ABS -=[Full WinOLS/ECM Titanium User] =- Remember! dirty hands are a sign of clean money шшш.αήkαbôôτ.Ćô.цk |
|||
05-01-2018, 02:57 AM,
Post: #152
|
|||
|
|||
RE: VVDI PROG Support/Feedback Thread
(04-01-2018, 22:14 PM)MEGACHIP Wrote:If so,please check your pm.(04-01-2018, 08:56 AM)Xhorsesupport Wrote: Firstly,connect the device to the pc,obverse the led light,the red led should light always,the yellow led should blink.if the yellow led doesn't blink,you should change a usb port or pc to have a try. |
|||
05-01-2018, 19:27 PM,
Post: #153
|
|||
|
|||
RE: VVDI PROG Support/Feedback Thread
BEST CHIPTUNING SERVICE BY Zenter Performance
Contact Skype: zenter-88 Facebook: https://www.facebook.com/ZenterPerformance -------------------------------------------------------------------------------------------------------------- highest Quality ChiPTuninG Files BY PTF Team https://performance-tuningfiles.com/ POWER BY TECHNOLOGY -------------------------------------------------------------------------------------------------------------- BEST CHIPTUNING SERVICE BY Jurebv Contact Skype: live:jure.coric_1 https://files.tuning-makarska.com/ -------------------------------------------------------------------------------------------------------------- - IMMO/ECU , ODO , AIRBAG , CARRADIO , TESTED SOLUTIONS UNDER MY SOFTWARE In progress TUNING STAGE1/DPF/SCR/EGR/TVA/FLAP/ START STOP OFF Software WHAT'S NEWS ! -Steering Angle Sensor Restore For LEXUS,TOYOTA,SUBARU,MITSUBISHI,VAG -Citroen DS5 Steering lock Renew/Write Code by dumps -Passat CCM Repair corrupted dump succes -VAG ECU SIMOS PCR 2.1 KM WITH CRC CORRECTED ! -IMMO OFF For NISSAN/INIFINITI with HITACHI ECU | CPU SH705X -Dacia Dashboard with Fujitsu MB96F6A6 Change km/Block Synchro Dash-ABS -=[Full WinOLS/ECM Titanium User] =- Remember! dirty hands are a sign of clean money шшш.αήkαbôôτ.Ćô.цk |
|||
10-01-2018, 23:10 PM,
Post: #154
|
|||
|
|||
RE: VVDI PROG Support/Feedback Thread
Hello . I Have problems with the vvdi programmer, I can't read all atmega 32,48,64 chip. Connection is correct, programmer says - check connect wire. What is it a problem.
|
|||
11-01-2018, 03:15 AM,
Post: #155
|
|||
|
|||
RE: VVDI PROG Support/Feedback Thread
(10-01-2018, 23:10 PM)tommaxx Wrote: Hello . I Have problems with the vvdi programmer, I can't read all atmega 32,48,64 chip. Connection is correct, programmer says - check connect wire. What is it a problem.1.if your mcu cable is v2,please change it to v3 following the modification in the "Connection diagram" 2.use the multimeter to test every connection point is right 3.and it's possible that chip are locked,the chip lock their communcation port,programmer can't communicate with them,so can't read. |
|||
27-01-2018, 06:29 AM,
Post: #156
|
|||
|
|||
RE: VVDI PROG Support/Feedback Thread
VVDI PROG latest software version V4.6.7 update
------------------------------------- v4.6.7 (2018-01-27) * This version DON't need update firmware * Fix some bugs + Add VVDI PROG USER MUNUAL 4.6.7 version in Doc folder * ESW3 change Read/Write mode + Add 25LC010, 25LC020, 25LC040, 25LC080, 25LC160, 25LC320, 25LC640, 25LC128, 25LC256, 25LC512 options in <1-EEPROM&FLASH>-><MICROCHIP> + Add TC97010(CLIP) option in <1-EEPROM&FLASH>-><TOSHIBA(CLIP)> + Add MB91F060, MB91F062, MB91F067, MB91F575, MB91F577, MB91F578C, MB91F579C, MB91F591B, MB91F592B, MB91F594B, MB91F596B, MB91F597B, MB91F599B, MB91F59AC, MB91F59BC options in <2-MCU>-><FYJITSU-MB91F> + Add MC68HC05E6 option in <2-MCU>-><MOTOROLA-MC68HC(7)05> + Add W203(AM29F400BB) option in <3-ECU>-><BENZ> + Add ME7 option in <3-ECU>-><BOSCH> + Add IAW 4AC.A4 option in <3-ECU>-><MAGNETI-MARELLI> + Add EIS-W203-1J35D(ADAPTER), EIS-W203-1J74Y(ADAPTER), EIS-W203-2J74Y(ADAPTER), EIS-W203-3J74Y(ADAPTER), EIS-W203-4J74Y(ADAPTER), EIZ-W209-HC12(ADAPTER), EIZ-W211-HC12(ADAPTER), EIZ-W209-ST12(ADAPTER), EIZ-W211-ST12(ADAPTER), EIZ-W215-ST12(ADAPTER), EIZ-W220-ST12(ADAPTER), EIZ-W230-ST12(ADAPTER), EIZ-W164-ST12(ADAPTER), EIZ-W169-V1-ST12(ADAPTER), EIZ_VITO_ST12(ADAPTER), EIZ_SPRINGTER(ADAPTER), EIS-W639-0L02M(ADAPTER), EIS-W639-1L02M(ADAPTER), EIS-W639-3K85K(ADAPTER), EIS-W639-1J35D(ADAPTER), EIS-W639-4J74Y(ADAPTER), HC05E6_REMOTE(0F82B) options in <4-IMMOBILIZER>-><BENZ> + Add EWS3—KLINE(0D46J)_READ, EWS3—KLINE(0D46J)_WRITE options in <4-IMMOBILIZER>-><BMW> + Add EPICA_BCM(--2009), SAIL_IMMOBOX(--2009) option in <4-IMMOBILIZER>-><CHEVROLET> (Support read PASSWORD) + Add IX35(2015)(MC9S12XD256) option in <4-IMMOBILIZER>-><HYUNDAI> + Add OPEL_IMMOBOX(--2009) option in <4-IMMOBILIZER>-><OPEL> (Support read PASSWORD) + Add JETTA_IMMOBOX(--2008) option in <4-IMMOBILIZER>-><VOLKSWAGEN> (Support read PASSWORD) + LINGZHI_M5(2016)(MC9S12HY64) option in <5-DASHBOARD>-><DONGFENG> + LAVIDA_DASHBOARD(D79F3422) option in <5-DASHBOARD>-><VOLKSWAGEN> + VERNA(D70F3421) option in <5-DASHBOARD>-><HYUNDAI> + TIGGO5(MB91F594BS) option in <5-DASHBOARD>-><CHERY> + PRIDE option in <7-AIRBAG>-><OTHERS> |