Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
XENTRY XDOS & PassThru how to install for dummies
17-12-2018, 13:17 PM,
Post: #481
|
|||
|
|||
RE: XENTRY XDOS & PassThru how to install for dummies 2018 (include Tips & Tricks))
X.D.O.S = Xentry Diagnostic OpenShell
Good luck |
|||
20-12-2018, 09:46 AM,
Post: #482
|
|||
|
|||
RE: XENTRY XDOS & PassThru how to install for dummies 2018 (include Tips & Tricks))
(13-12-2018, 13:47 PM)pesona Wrote: probably it is a hardware (sdconnect) failure mate. I have tried with w204 in das and i works so maybe not a bad connect. Multiplexer is purchased with industrial engine license and works with Xentry, could it be locked, and can only be used on Mercedes industrial engine? |
|||
22-12-2018, 17:52 PM,
Post: #483
|
|||
|
|||
RE: XENTRY XDOS & PassThru how to install for dummies 2018 (include Tips & Tricks))
can someone help ? i have installed all from the first post.
I have install the driver for a 5054a and from a toyota vci. But every time when i will start from desktop the xentry diagnosis.exe i become the error code "Fatal error (104) is is no sae j2534 config" And error 1: "selectptdevice could net be started" how can i select ? |
|||
22-12-2018, 18:36 PM,
Post: #484
|
|||
|
|||
RE: XENTRY XDOS & PassThru how to install for dummies 2018 (include Tips & Tricks))
Hi everybody,
I have strange issues. I can not unable ingintion in 12.2018 by grandpa method or program exe. It was working great on 9.2018 but now I have ignition small window but can not make tick active. Any ideas please what can I check additionaly ? Thanks for help ! |
|||
23-12-2018, 00:46 AM,
Post: #485
|
||||||||||
|
||||||||||
RE: XENTRY XDOS & PassThru how to install for dummies 2018 (include Tips & Tricks))
@Cryjack, @Joe2 your xentry passthru installation is not normal. if it is possible, try to re-install again from scratch and please look carefully when xentry installs pre-requisite, and then do all addons update or try this @Cryjack go to c:\program files (x86)\mercedes-benz\xentry\bin\selectPTdevice\ run 'selectPTdevice.exe' (double click), then look if there are options to choose the pt device. choose which one you want, and try to run xentry. @Joe2 mine is 2018-12 too and the ignitionenabler.exe file is done as it should be. try to extract and copy this global.sim file to c:\programdata\mercedes-benz\csd\writefil\sim
|