Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
VCI not recognized by GDS after recent update!
13-07-2018, 04:02 AM,
(This post was last modified: 13-07-2018, 04:07 AM by margut.)
Post: #1
|
|||
|
|||
VCI not recognized by GDS after recent update!
Just this week, July 9, 2018, I tried to update GDS online. After reading the pop up message, I modified the server connection URL to "ccc.hyundai.com" hoping to get some fresh updates. Indeed, I got 2 or 3 updates as far as I can remember. I rejoiced at that time!
However, when I connected to Santa Fe (CM) 2007, 2.2 Diesel, an error popped up saying "VCI is not recognized by GDS properly". I then powered off the VCI and reconnected however the same error popped up. So I updated the driver through the device manager in Windows 7 x32 and was prompted "Driver was updated successfully". Again, the same error popped up when connected to the car. As usual, I was prompted to update the firmware but I did not because of fear to brick this chinese cloned VCI. I believe the latest 2 or 3 updates I got from the new server URL "ccc.hyundai.com" has caused this error. Or maybe I am wrong. So I reverted the server URL back to the previous one before it was changed to "ccc.hyundai.com". Then I attempted an online update but there is no more available. Now the VCI cannot be used. Did anybody encountered this problem? Can anybody help and share how will this be resolved? I hope somebody can share and help me out. Thanks in advance... |
|||
13-07-2018, 04:57 AM,
Post: #2
|
||||||||||
|
||||||||||
RE: VCI not recognized by GDS after recent update!
As I can see the VCI has no firmware Did you powered it up? Did you firmware update? Is your tool VCI the blue one? Maybe the blqacklist is casuse this Put it in Factory mode and try again the firmware update I didn;t tested in a car but when I saw your post I tried to upgrade my system and my VCI too Check this Good luck
|