[Lukinecek]

Hi,

I tried to flahs my camera (areaview) unit 5Q0907556 SW 0327 to SW 0329 (receiver from E*WIN). But at the end there was a mistake like "No_End_Line_Programming   (no ECU data_set) - see attachement. I used VCP engine, registered.
Does anybody know what does it mean?

[rch11]

Make a reflash ODIS engineer

[kreativ]

Hi,

I tried to flahs my camera (areaview) unit 5Q0907556 SW 0327 to SW 0329 (receiver from E*WIN). But at the end there was a mistake like "No_End_Line_Programming   (no ECU data_set) - see attachement. I used VCP engine, registered.
Does anybody know what does it mean?

Upload new dataset in ecu.

As it says on picture [ECU no dataset]

[Lukinecek]

Hi,

I tried to flahs my camera (areaview) unit 5Q0907556 SW 0327 to SW 0329 (receiver from E*WIN). But at the end there was a mistake like "No_End_Line_Programming   (no ECU data_set) - see attachement. I used VCP engine, registered.
Does anybody know what does it mean?

Upload new dataset in ecu.

As it says on picture [ECU no dataset]

Yes I would like to do that, but impossible - see another picture (error request..)

[kreativ]

Hi,

I tried to flahs my camera (areaview) unit 5Q0907556 SW 0327 to SW 0329 (receiver from E*WIN). But at the end there was a mistake like "No_End_Line_Programming   (no ECU data_set) - see attachement. I used VCP engine, registered.
Does anybody know what does it mean?

Upload new dataset in ecu.

As it says on picture [ECU no dataset]

I think its because there are new data from 0327 to 0329 and that file you loaded is only 0327. 
Make a request at VCP support for new 0329 sw zdc 


Yes I would like to do that, but impossible - see another picture (error request..)