[zapdus]

Hi

I made several solutions for adblue and dpf on this car ecu

Before touching ecu with original file car had nox sensors DTC

P229F Nox sensor 2 bank 1
P220F Nox sensor circuit control radiator
P2200 Nox sensor circuit bank
P22AA Nox sensor heather circuit

Some solutions I tried have limp mode or engine light on

I tried to disconnect sensors, first adblue, then dpf pressure and temp sensor, then nox sensors but the best I got is engine light and no limp mode

Now car is running without DTC but has MIL on

I also tried to connect all again, write original file and reset all related to adblue and dpf, but still engine light on without DTC

HW: 6519040800
SW: 6519022402
SW ver.:
Spare: 6519011902
Engine:
HW Ver.:
SW upg.: 6519037937
Installation: CRD3-651-WMIC3D3

[Gabriel130592]

Resets the DPF soot counter.
Disconnect Adblue module.
Programs my file.
Please test & report.
Select reputation & Thanks.
Regards

[zapdus]

Resets the DPF soot counter.
Disconnect Adblue module.
Programs my file.
Please test & report.
Select reputation & Thanks.
Regards

In this file limp mode
max 2900 RPM
and engine light MIL on

no DTC

[Tscheppo]

Send the ori file what you have read out where nothing has been edited yet!!

[zapdus]

Send the ori file what you have read out where nothing has been edited yet!!

File on first post its the ori

Anyway again attach

[rs@chip]

Send the ori file what you have read out where nothing has been edited yet!!

File on first post its the ori

Anyway again attach

your file off.. some of those need dpf sensors disconected

pass sent!