[wxwwxw]

I have a FEM with a key on the table that I use to test the NBT unit
I damaged the EEPROM in FEM, two legs of the 95128 system. 
   
Now in FEM it disconnects the contactor cyclically.I need the contents of this memory to run FEM. Next, I will try to add the cleaned key using the BMWExplorer 2018.12 clone.

Can anyone share the contents of memory 95128 for such a FEM module?
   

[DSESET86]

I have a FEM with a key on the table that I use to test the NBT unit
I damaged the EEPROM in FEM, two legs of the 95128 system. 

Now in FEM it disconnects the contactor cyclically.I need the contents of this memory to run FEM. Next, I will try to add the cleaned key using the BMWExplorer 2018.12 clone.

Can anyone share the contents of memory 95128 for such a FEM module?

here you go

[wxwwxw]

Thanks, it works very well.

I thought that after uploading the contents of memory 95128 from another FEM, I would lose the key, but here's a surprise. The key works.

[DSESET86]

Your welcome. Glad it helped!

[Jumper]

What did you do with your wakeup WUP with a donor eeprom? Did you have to reset the key? Did you have central locking and ignition without a key on the coil?

[wxwwxw]

I had a FEM+ Key assembled on a table with a start-stop button and a coil.

I damaged the EEPROM in FEM. But as it turned out, the key memory is not stored in 95128. The old key turns on the ignition

[Jumper]

I had a FEM+ Key assembled on a table with a start-stop button and a coil.

I damaged the EEPROM in FEM. But as it turned out, the key memory is not stored in 95128. The old key turns on the ignition

The WUP is in the eeprom for key detection