[ZackC77]

I'm attempting to use ISTA/P with just a K+DCAN cable and am running into some issues. Once it starts completing the initial identification I get an error-something about the vehicle alignment, which then goes away after clicking okay. Then once it gets further it says that I need to replace a bunch of ECU's and I need to manually enter their part numbers. I've previously used an older version of ISTA/D and it came back with no errors on any of my modules and now I ran that to see and it appears it may be losing communication-There's a bunch of modules that just stay red and it says Fault Memory: Unknown. So I'm thinking I may have an issue with my cable settings? Any way someone could post the appropriate settings or any other advice would be helpful.