[hulahans]

Standalone diagnosis works quite good, but i can not make measurement Plan.

Everytime Ista says i have to test the car first, and i have done that several times.
Before i copied complete psdzdata folder from ista p 59.4 to C:\Rheingold\PSdZ\data

Dont know whats wrong, but i only tested with ETH (ignition voltage was not shown ) not with my icom next.
Any ideas?

I'm not sure but in the last versions I had the same Problem with ETH cable. Everything works when I use an ICOM. Try it with your ICOM Next.

Yes with icom next, but will test with eth too

Oh if that works that would be cool just for the fact that it works and I spent countless days earlier this year to no avail... it's also good news that for those of us with newer BMW platforms, psdZs are smaller thanks to your observation and dracon's reply!

Tested it again,ETH still don t work for programming and measurement plan .

I hope that with icom the most ECUs (NBT,Kombi) are possible to flash without router or dhcpsrv like ista p.
Will test the next days