[bawareca]

Both ISTA/D and /P have been working so far great for me on E and F series. But now i have to program a few modules on a '15 i3 and I am lost. When i open the ISTA/P loader and choose i vehicles, it starts up and finds the VIN, but after that it cycles for a long time and finally gives error. I then installed the SDP, but when i try to use it in ISTA/D I get message to run the vehicle test first. Even if I run the test again it will still display the message. I use ICOM A1 and the diagnostic runs just fine with this car.