[e46ad]

Hello folks. I have a major problem. I've updated ICOM A2 to the latest firmware. Package Image: 3.15.02 System Image: 1.26. and application image: 1.41. Software versions ISTA+ 4.12.12 and ISTA-P 3.65.0.500. Both are standalone versions. I also have connected ICOM A2 and Computer to a router running DHCP server. I can scan and diagnose 2013 and up cars. I could also program E-Series using the same configuration. Here is the part I need help with. On my F32, I recently had to replace the FEM module. When I go into ISTA+ and try to program and code the FEM module I get this error

"Faulty ICOM vehicle connection. The programming scopes are therefore not available. The possible causes is an incorrect ICOM connection sequence. Perform the following steps: End process. Switch on ignition or activate PAD. Unplug the ICOM vehicle interface. Reconnect the ICOM vehicle interface at the vehicle. Start new process."

I followed the instruction to the tee but no dice.

Your help would be greatly appreciated.

Hi have you extracted the Coding and Programming files into the correct folders,

The SDP and BPL ?