[bitcosmin]

Hi bitcosmin

I've also just started using ista+ to update my car G12 7 series. Last week I've updated complete I-level and as part of the procedure after finishing the coding I was required byu ISTA to calibrate vehicle height sensors - putting the vehicle on a completely flat and level surface, all doors closed, laptop and yourself out of the car & with a precise measuring tape carry out the measurements as indicated by ISTA on all four wheels.

This calibration function tells the car the real level condition of each side, encodes it to the module & then recalibrates itself according the predetermined height value that BMW established for your vehicle.

This function can be called up any time in ISTA through Vehicle management/Service functions/Chassis and suspension/Electrocnic ride height adjustment/Ride height adjustment

I'm not sure if you'll have the same menu structure for your car. quite possibly yes.

Although there's a big difference, in your car F11 there's only self-leveling air springs on the rear axle

Thanks! I will try these days, even if I did it few days ago, with no positive result: the rear suspension goes back to that low position (only few cm above the tyres level)! I have no idea why that happens, but I strongly believe that the problem might be a physical deviation of the height sensors on the rear axle!