[laguna]

Ok thank you i will write tommorow... Just again how do i know which are the drivers, cuz i tested , with pluging in and out the usb cable and nothing changes in device manager...


If you connect it without the obd then you get a generic usb hub.



And if you connect it to obd as suggested earlier by other members then you'll have either four or one driver depending on which one you have , the earlier or the later version of canclip.

This is how it looks without connected to car


I guess the drivers are not installed???


Sent from my iPhone 5S using Tapatalk

if you still post pictures about some strange connection,why you not post some about your entire tool , cause seems to be a old stile one,or something not seems to be a common one , by other side I told you already,if you wish to see something in device manager then you need to have your tool(Clip device) connected to a Renault car,who have ignition on(engine stopped) and your laptop or PC,so stop posting stupid questions,if you not follow our advices

Alright

Well i plugged in car and i switched the usb ports and it pops up the window about installing new device, it installed only diagcom hub driver( see the pictures)...

And it still says error no sensor detected...

Its frustrating

       


Sent from my iPhone 5S using Tapatalk

---

well there are two beeps while i iam connecting the obd to car, in device manager i only see diagcom hub, and still when i start the clip says no sensor detected... thats the problem i am asking for maybe its stupid but... its a problem and i need help, if u willing to help me i would be very grateful

also how do i instal those JCAE drivers, i guess thats the one which missing