[SteelFK1]

I like to test and take risks and try to learn from my mistakes.

My way of thinking and probably my mistake was: I always changed the data without doing a test drive.

I should have changed the values, driven a lap and changed again, I didn't do that.

I just thought that if I enter 610mm, which is then also from the rim to the side part about 610mm away, was surprised that the at 610mm always went up instead of staying in the same place.

Apparently I have not understood the system, is not bad - you learn from it.

@larshutten: You say I should enter the real value, do a test drive and enter the real value again, is that right?

Then test drive again to be sure and then enter the desired MM and drive again? Or have I misunderstood the procedure?