[mar.wo]

Try to flash it with an external programmer.
If the message is " Is your chip empty" then you you wans't able to flash it using OPCOMFut
Si my advise is to flash your tool ( fw.1.12 ) with an external programmer with any firmware aviable from 1.33 to 1.60
Then check if the tools is working.
If the relays do tyk, tyk, tyk it shows that the PIC MCU it isn't flashed well or blocked
Good luck

P.S. - when you flash a not real MCU in a op-com v6 you will hear same tyk, tyk....tyk

Thx U very much for quick reply. MY opcom is 5.I think it's blocked. What external programmer /device do U suggest to use to program/flash a new Pic//